Instruction to Author

Manuscript Preparation Guidelines for Journal
(Article title should not exceed 25 words)
Manuscripts should be compiled in the following order:
 Title page/Cover letter;
 Abstract;
 Main text; (Introduction, Material & Method, Result, Discussion, Conclusion)
 Acknowledgments;
 Declaration of interest statement;
 Appendices (as appropriate);
 References;
 Tables with captions (on separate pages);
 Figures; figure captions (as a list).
Cover Letter: All submissions should be accompanied by a 500 word or less cover letter briefly
stating the significance of the research, agreement of authors for publication, number of figures
and tables, supporting manuscripts and supplementary information.A title page should be
provided comprising the manuscript title plus the full names and affiliations of all authors
involved in the preparation of the manuscript. One author should be clearly designated as the
corresponding author and full contact information, including phone number or mobile number
and email address, provided for this person. Three to six key words that are not in the title should
also be included on the title page. The keywords will assist indexers in cross indexing your
article.

Author Name1
Faculty/Department/Division
University
City,Postcode,Country
email@address.com

Author Name2 “* for corresponding author”
Faculty/Department/Division
University
City,Postcode,Country
email@address.com

Abstract
Should start on a new page after the title page and should present the aim of the study, material
and methods, results and conclusions, not more than 300 words. All the three categories, Review
Articles, Research papers and Short Communications should have an Abstract.

Limited to 300 words)

Keywords: Keyword1, Keyword2, Keyword3, Keyword4, Keyword5. (3—10 keywords)
GFNPSS International Journal of Multidisciplinary Research

Introduction:
Should start on a new page and should clearly indicate the aim of the study.
Materials and Methods
Should start as a continuation to introduction on the same page.All important materials used
along with their source shall be mentioned. The main methods used shall be briefly
described,with references. New methods or substantially modified methods may be described in
sufficient detail. The statistical method and the level of significance chosen shall be clearly
stated.

Results:
All results presented in tabular or graphical form shall be described in this section. All Tables
and figures must have a title and a legend to make them self-explanatory and they should be
given numbers. Each table or figure should be on main body of the text.

Discussion:
should contain a critical review of the results of the study with the support of relevant literature.
Unsupported hypothesis should be avoided.

Conclusions:
This must summarize the main paper. Ensure that extrapolations are reasonable and that
conclusions are justified by the data presented, and indicate if the study design can be
generalized to a broader study population.

Acknowledgements:
All acknowledgments should be typed in one paragraph directly preceding the reference section.

Tables/Figures:
Incorporate tables and/or figures with their legends into the main body of text.
Note: If an author fails to submit his/her work as per the above instructions, they are pleased to
maintain clear titles namely headings, subheading.

References
Only published or accepted manuscripts should be included in the reference list. Meetings
abstracts, conference talks, or papers that have been submitted but not yet accepted should not be
cited. All personal communications should be supported by a letter from the relevant authors.

Scient uses the numbered citation (citation-sequence) method. References are listed and
numbered in the order that they appear in the text. In the text, citations should be indicated by the
GFNPSS Global Nursing Journal of India
reference number in superscript. Multiple citations within a single set of superscript should be
separated by commas. Where there are three or more sequential citations, they should be given as
a range. Example: “… now enable biologists to simultaneously monitor the expression of
thousands of genes in a single experiment1,6-8,29.” Make sure the parts of the manuscript are in the
correct order for the relevant journal before ordering the citations. Figure captions and tables
should be at the end of the manuscript.
Authors are requested to provide at least one online link for each reference as following
(preferably PubMed).
Because all references will be linked electronically as much as possible to the papers they cite,
proper formatting of the references is crucial. Please use the following style for the reference list:

Examples

Published Papers
Iyengar BS, Dorr RT, Remers WA. (2004). Chemical basis for the biological activity of Imexon
and related Cyanaziridines.J Med Chem, 47, 218-23.
Book:
Chandrasekaran SK, Benson H, Urquhart J. (1978). Methods to achieve controlled drug delivery:
The biomedical engineering approach. In: Robinson JR, ed. Sustained and Controlled Release
Drug Delivery Systems. New York: Marcel Dekker, 557-93
Vyas SP, Khar RK. (2001). Targeted and Controlled Drug Delivery New Delhi, India: CBS
Publisher and Distributor.

Thesis:
Upadhyay UM, Ph.D. Thesis, Phytochemical Investigation ofEnicostemmalittoraleon insulin
resistance and diabetes mellitus.Gujarat University, November, 2000.

Conference
Seabag M (1999) Constructive Induction: A Version Space-based Approach. Proceedings of the
International Joint Conference on Artificial Intelligence.

Proofs and Reprints
Electronic proofs will be sent as an e-mail attachment to the corresponding author as a PDF file.
Page proofs are considered to be the final version of the manuscript, no changes will be made in
the manuscript at the proof stage. Authors will have free electronic access to the full text
(HTML, PDF and XML) of the article. Authors can freely download the PDF file from which
they can print unlimited copies of their article
GFNPSS International Journal of Multidisciplinary Research